Consistent Crash to Desktop

Ask about specific settings, like fabric properties, or the difference between the sewing tools. These would be things you would expect to see in a software manual.
Post Reply
cgchanger
Posts: 1
Joined: Wed Oct 24, 2018 4:14 am

Consistent Crash to Desktop

Post by cgchanger » Wed Oct 24, 2018 4:22 am

Hello;

I've been unable to export any sort of animated format from my simulation in MD. I've observed this before if I try to export to Alembic on meshes beyond a certain density. I've been able to solve that if I export the mesh via FBX, and then use Point Cache 2 to export the animation itself.

This time around, however, I've had no breakthrough.. the clothing piece is a relatively simple jacket with a hood; with particle density ranging from 10 - 14. Exporting even Point cache 2 sends me back to desktop without any sort of output.

Can you walk me through this? thanks.

Post Reply